Briggs & Stratton 12K300 Specifiche Scaricare il pdf (Pagina 10)

Air Cleaner

1. Loosen cover screw. Remove cover and air

cleaner assembly from base.

2. Remove air cleaner assembly from inside of cover

and disassemble.

3. To service foam air cleaner:

a. Wash in liquid detergent and water.

Do not use pressurized air or solvents to clean

foam. Pressurized air can damage foam; solvents

will dissolve foam.

CAUTION

b. Squeeze dry in clean cloth.

c. Saturate in engine oil.

d. Squeeze in clean, absorbent cloth to remove

ALL EXCESS oil. If very dirty or damaged, replace it.

4. Reassemble retainer on foam air cleaner. Install

this assembly into cover.

5. Insert tabs on cover into slots in base. Tighten

cover screw securely.

RET AINER

AIR CLEANER ASSEMBL Y

FOAM AIR CL EANER

COVER

BASE

Ensue air cleaner, retainer, and cover are

properly installed before starting engine.

WARNING

Spark Plug

Check the spark plug every 100 hours. Replace the

spark plug if upon inspection the electrode is burned or

worn. Ensure the spark plug is clean. Check the gap

with a feeler gage and reset to .76 mm or 0.030 in. if

necessary. Use only Briggs & Stratton Spark Tester

(part number 19368) to check for spark.

.030” (0.76 mm) WIRE GAGE

Note: In some areas, local law requires using resistor

spark plug to suppress ignition signals. If this engine

was originally equipped with resistor spark plug, use

same type for replacement.

Air Cooling System

Debris may clog engine’s air cooling system, especially

after prolonged service.

1. Remove blower housing and clean area shown to

prevent overheating and engine damage.

2. Clean areas shown.

3. Reinstall housing ensuring all hoses and wires are

in place.

CLEAN

Cleaning Debris

Do not use water to clean engine parts. Water

could contaminate fuel system. Use a brush or dry

cloth.

CAUTION

• Engine parts should be kept clean

to reduce the risk of overheating

and ignition of accumulated debris .

WARNING

Daily or before every use, clean accumulated debris

from engine. Keep linkage, spring and controls clean.

CLEAN

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento

Briggs & Stratton 12K300 Specifiche Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Pompe di calore Briggs & Stratton 12K300