Briggs & Stratton 074001 Specifiche Scaricare il pdf (Pagina 60)

Operating Instructions

CrossFire 4.2

Section 3-1

START UP

Perform daily/periodic maintenance as specified in this Owner Manual.

Connect all required hoses.

Connect the cleaning tool to the length of hose required to perform the

cleaning.

CAUTION: Mix tank must be full prior to ignition.

Start engine (choke as required). Engine may be started in either the

run or idle throttle position.

Idle RPM is approximately 2000. Run RPM

is 3100.

NOTE: The low speed (2000 RPM) throttle setting is for “start up”

and “shut down” only.

Do not run the machine for long periods of

time at the “idle” setting. Damage to the throttle solenoid may occur.

Spray the wand to void all air from the system. When the mix tank

begins a fill cycle, the chemical flowmeter may be adjusted to your

desired setting. Set your cleaning pressure at 300 PSI.

NOTE: A chemical flowmeter set at 5 GPH is a 1 to 30 mix ratio and

10 GPH is a 1 to 15 ratio. When the flowmeter is set at 10 GPH, you

will be using what most chemical manufacturers recommend at 5 .

GPH.

Run the machine for several minutes under load (8 to 10“ HG) until

your desired temperature is achieved.

HydraMaster Corporation

4/5/95

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 165 166

Nessun commento

Briggs & Stratton 074001 Specifiche Pagina 60