Briggs & Stratton 250000 Specifiche Scaricare il pdf (Pagina 193)

100

101

Fig. 11:

Bumper tang (1)

Hole in pulley (2)

Guide lug (3)

Eyelet (4)

Fig. 11

Fig. 12:

Rope eyelet (1)

Hole in pulley (2)

Fig. 12

Install Rope

A rope inserter tool may be made by using a piece of

music wire or spring wire 1/16” diameter, and flattening

the end (2) as shown in Fig. 13.

1. Inspect rope. Replace if frayed.

2. Insert rope through wood handle (1) and tie a fig-

ure eight knot, Fig. 13.

3/32” (2.4 mm)

6” (152.4 mm)

1/8”

(3.2 mm)

1/16” (1.6 mm)

Fig. 13

3. Insert pin (1), Fig. 14, through knot and pull tightly

into handle (3), Fig. 14. ALWAYS SEAL BOTH

ENDS OF KNOT.

4. If re-using old rope, burn ends of rope with a

match.

5. Using caution, wipe with waste cloth while it is still

hot to prevent swelling and unraveling.

3/4”

(19.1 mm)

Fig. 14

NOTE: When installing a new rope, check parts list

to be sure correct diameter and length rope

are used.

6. Thread wire and rope through rope eyelet in

housing and out pulley hole. (NOTE: Rope must

pass inside a guide lug on metal pulley, [3].)

Fig. 11.

Old Style with Guide Lug

Tie a knot in rope and pull tight. Make sure knot in

pulley does not contact bumper tangs, Fig. 11.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 337 338

Commenti su questo manuale

Nessun commento

Briggs & Stratton 250000 Specifiche Pagina 193

Commenti su questo manuale

Prodotti e manuali riguardandi Accessori e componenti per motoveicoli Briggs & Stratton 250000