Briggs & Stratton 250000 Specifiche Scaricare il pdf (Pagina 74)

NOTE: SPECIFICATION TABLES BEGIN ON PAGE 63 OF THIS SECTION.

Install Carburetor and Fuel Tank

Rotary Choke (Pulsa-Jet)

1. Connect governor linkage to carburetor linkage

and using Tool #19305, Offset Screwdriver, Tool

#19391, Torx Wrench, or open end wrench (2),

install two screws (1) holding carburetor to engine,

Fig. 89.

2. Install screw to bottom of fuel tank bracket (3).

Fig. 89

Choke-A-Maticr with Slide Choke (Pulsa-Jet)

1. Install carburetor and tank as one assembly.

2. Hook throttle link (1) into carburetor throttle and

governor blade.

3. Raise carburetor into place, insert a new gasket

and fasten with mounting screws.

4. Install governor spring (2), Fig. 90.

Fig. 90

5. If choke slide does not fully close (1), replace link

or use flat nose pliers to bend choke link (2),

Fig. 91 (do not over bend).

6. Speed adjustment lever must make good contact

against stop switch (3) when moved to stop

position.

Fig. 91

Install Carburetor and Tank Assembly

Model Series 60000, 80000, 110000, 130000

(Pulsa-Jet)

1. Install carburetor and fuel tank as an assembly.

2. Hook throttle link into carburetor throttle and

governor lever. (For various hook-ups, see

Remote Control, Section 4.)

3. Raise carburetor into place, insert a new gasket

and fasten with mounting screws.

4. Install governor spring (1). Install stop wire (2) and

remote control where used, Fig. 92.

Fig. 92

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 337 338

Nessun commento

Briggs & Stratton 250000 Specifiche Pagina 74